1997-01 JEEP CHEROKEE
shift boot installation guide

1. Start by removing the gear shift knob. The easiest way to remove the stock shifter is by using a large pipe wrench and turning counterclockwise. Use a wash cloth or something soft to cover the shifter to avoid damaging.

On 02+ models the shift knob removal is different! The shift knob does NOT turn off. To remove it, one has to pry off the cap on the very top of the shift knob and then remove the nut holding the knob in place. The cap has the details on it for the 1, 2, 3, 4, 5, R. Taking off the cap is difficult! You need to use a very small screwdriver and be extremely careful not to ruin it.

2. Once the shifter is removed, remove the old boot and bracket by simply pushing in the front end (the side nearest the emergency break) until you can remove the bracket.

3. Remove the rubber boot from the bracket, and clean the bracket with alcohol or similar to promote adhesion.

4. Glue the leather boot on the bracket. Make sure the bottom of the boot can be pushed into the recess on the bracket.

5. Thread the shifter through the center of the leather and work the shifter bracket back into place until firmly secured. Finally, add the shifter knob.

CONGRATULATIONS - YOU HAVE SUCCESSFULLY INSTALLED YOUR NEW LEATHER BOOTS!

Useful tip

You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.

Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.